Genie S-85 Manuel d'utilisateur télécharger pdf (Page 25)

Part No. 43650 Genie S-80 & Genie S-85 23

Operator's ManualSecond Edition · Fifth Printing

Operating Instructions

Starting the Engine

1 At the ground controls, turn the key switch to

the desired position.

2 Be sure both ground and platform control red

Emergency Stop buttons are pulled out to the

ON position.

3 Gasoline/LPG models: Choose fuel by moving

the fuel select switch to the

desired position.

4 Move the engine start toggle

switch to either side. If engine fails

to start or dies, the restart delay

will disable the start switch for

3 seconds.

If engine fails to start after 15 seconds of cranking,

determine cause and repair any malfunction. Wait

60 seconds before trying to start again.

All models: In extreme cold conditions, 20°F (-6°C)

and below, warm engine for 5 minutes to prevent

hydraulic system damage.

Gasoline/LPG models:In extreme cold conditions,

20°F (-6°C) and below, machine should be started

on gasoline, then switched to LPG.

Emergency Stop

Push in either ground or platform red Emergency

Stop button to the OFF position to stop all functions

and turn engine off.

Repair any function that operates when the

Emergency Stop button is pushed in.

Selecting and operating the ground controls will

override the platform Emergency Stop button.

Do Not Operate Unless:

You learn and practice the principles of safe

machine operation contained in this operator's

manual.

1 Avoid hazardous situations.

2 Always perform a pre-operation

inspection.

3 Always perform function tests prior to use.

4 Inspect the work place.

5 Only use the machine as it was intended.

Fundamentals

The Operating Instructions section provides

instructions for each aspect of machine operation.

It is the operator's responsibility to follow all the

safety rules and instructions in the operator's,

safety and responsibilities manuals.

Using the machine for anything other than lifting

personnel and tools to an aerial work site is unsafe

and dangerous.

Only trained and authorized personnel should be

permitted to operate a machine. If more than one

operator is expected to use a machine at different

times in the same work shift, they must all be

qualified operators and are all expected to follow all

safety rules and instructions in the operator's,

safety and responsibilities manuals. That means

every new operator should perform a pre-operation

inspection, function tests, and a work place

inspection before using the machine.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32 33

Commentaires sur ces manuels

Pas de commentaire

Genie S-85 Manuel d'utilisateur Page 25

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Genie S-85