Genie AWP 114002 Manuel d'utilisateur télécharger pdf (Page 21)

Operator’s ManualThird Edition • Fourth Printing

Part No. 114002 Genie AWP Super Series 19

Do Not Operate Unless:

You learn and practice the principles of safe

machine operation contained in this operator’s

manual.

1 Avoid hazardous situations.

2 Always perform a pre-operation

inspection.

3 Always perform function tests prior to use.

4 Inspect the workplace.

5 Only use the machine as it was intended.

Fundamentals

The Operating Instructions section provides

instructions for each aspect of machine operation.

It is the operator's responsibility to follow all the

safety rules and instructions in the operator's,

safety and responsibilities manuals.

Using the machine for anything other than lifting

personnel, along with their tools and materials, to

an aerial work site is unsafe and dangerous.

If more than one operator is expected to use a

machine at different times in the same work shift,

each operator is expected to follow all safety rules

and instructions in the operator’s manual. That

means every new operator should perform a pre-

operation inspection, function tests and a work

place inspection before using the machine.

Setup

1 Position the machine on a firm surface directly

below the desired work area.

2 Connect to the appropriate power source:

DC models: Connect the battery pack.

AC models: Connect to a grounded 15A AC

power supply. Use a 12 gauge / 3.3mm

3-wire

grounded extension cord no longer than

50 feet / 13 m.

Air models: Connect the air line.

3 Insert the key and turn to platform control.

4 Pull out the red Emergency Stop button at the

ground controls and twist to release the red

Emergency Stop at the platform controls. Be

sure the power light is on or the air pressure

gauge reads 80-110 psi / 5.5 - 7.8 bar.

5 Install the outriggers and adjust to level the

machine and raise the base casters slightly off

the ground.

6 Be sure all four interlock display lights at the

ground controls are on and all four outriggers are

in firm contact with the ground.

7 Use the bubble level to

make sure the machine is

level.

Note: If adjustment is necessary, check the bubble

level and interlock display again to make sure the

machine is level and all four interlock display lights

are on.

Operating Instructions

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Genie AWP 114002 Manuel d'utilisateur Page 21

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Genie AWP 114002