Genie TZ-50 Manuel d'utilisateur télécharger pdf (Page 20)

18 Genie TZ-50 Part No. 114164

Operator's Manual Second Edition • First Printing

FUNCTION TESTS

Test Outrigger Interlock

23 Place the boom in the stowed position.

24 Push and hold the blue function enable button.

Push and hold one outrigger button and raise

the outrigger off the ground.

25 Push and hold the blue function enable button

and activate each boom function.

Result: All boom functions should not operate.

26 Use the leveling buttons to lower the outrigger.

27 Repeat this procedure for each outrigger.

28 Use the function enable buttons and the auto

level button or the outrigger leveling buttons to

make sure the machine is level.

29 Raise the platform approximately 2 feet / 60

cm.

30 Push and hold the blue function enable button

and attempt to raise each outrigger off the

ground.

Result: The outriggers should not raise.

Test the Tilt Sensor

31 Raise the boom 2 feet / 60

cm.

32 Turn the key switch to

platform control.

33 Locate the tilt sensor below

the ground control box. It is

the sensor farthest to the left.

34 Press down one side of the

tilt sensor.

Result: The alarm should sound.

35 Lower the boom.

At the Platform Controls

36 Pull out the platform red Emergency Stop

button to the on position.

Test Emergency Stop

37 Push in the platform red Emergency Stop

button to the off position.

Result: All platform control functions should not

operate.

38 Pull out the platform red Emergency Stop

button to the on position.

Test Boom Functions and Function Enable

39 Do not push a function enable button. Attempt

to activate each boom function button.

Result: All boom functions should not operate.

40 Push and hold the blue function enable button.

Activate each boom function button.

Result: Primary boom up, primary boom

extend, secondary boom up, platform level up,

jib boom up, platform rotate left and turntable

rotate left should all function.

41 Push and hold the yellow function enable

button. Activate each boom function button.

Result: Primary boom down, primary boom

retract, secondary boom down, platform level

down, jib boom down, platform rotate right and

turntable rotate right should all function.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 40 41

Commentaires sur ces manuels

Pas de commentaire